Reducing the water content (sammying) and shaving of the pickled hides are done mechanically. Chromate allergy is frequently observed in tannery workers (Athavale et al. 2007; Dickel et al. 2002; Hansen et al. 2002). Contact allergy to flower and leaf extract of the mimosa tree (Guin et al. 1999)
and urea formaldehyde resin has also been reported (Sommer et al. 1999). Finishing stage In a post-tanning process, semi-finished leather undergoes dyeing, RG-7388 research buy fat liquoring and coating to create elasticity, softness, impermeability and brightness of the tanned leather. Fat liquoring is used to soften the fibres of the hides and to increase water resistance using sulphonated oil. The coloured and fat-liquored leather is treated in a setting-out machine to make them smoother and then placed in a vacuum dryer to dehydrate the leather. After the drying process, the skin fibres have bonded to each other causing
the hardening of the leather. Therefore, staking is done to soften the leather using a heavily vibrating metal pin. Leather is then stretched and pulled on a metal frame (toggling) and undergoes a trimming process to remove the unwanted parts of the hide. The last step in the finishing stage is the application of a protective and decorative coating. A water-based dye containing an anionic azo-dye is applied, which binds to the cationic surface of the leather and is completed with formic acid and acetic acid. A benzidine-based dye MK5108 nmr also used in one of these factories. Polyethylene acrylate, polyurethane, nitrocellulose and biocide are added if needed. In this stage, workers are Givinostat purchase exposed to different sensitizers such as azo-dyes, PAK6 acrylates, formaldehyde and glutaraldehyde (Dickel et al. 2002; Ancona et al. 1982; Goon et al. 2008; Mancuso et al. 1996). Work safety standards and the use of personal protective equipment (PPE) Occupational dermatoses risk in tanneries is mainly related to the frequent and the prolonged exposure of the workers’ skin to chemical substances, to hot and humid environmental conditions and to machinery equipment. Workers are exposed to hazardous chemicals through skin absorption, inhalation and ingestion. Workers
at the beam house and tanning area are exposed to chemicals during the whole process including cleaning and disposing the chemical wastes. During the process, chemicals emit fumes, mist, vapours or dust thus exposing the workers to airborne chemical pollutants. Personal protective equipment required by the workers in this area is gloves, apron, safety boots, goggles and respirator. Respirators were not available. Almost all the workers wore a thin plastic apron that did not cover all the parts of the body that were exposed to chemicals. They also wore plastic boots that covered the lower legs and the feet. Some workers, when holding a hide or pickled hide, used synthetic rubber gloves that covered their hands and lower arms.