In this study, the intercalation of 3,4-dichlorophenoxyacetic acid into the interlamellae of zinc-aluminum-layered double hydroxide (ZAL) was accomplished by a simple direct self-assembly method for the formation of a new organic–inorganic nanohybrid material. The physicochemical properties and the controlled release of the agrochemical were investigated and discussed. Methods All chemicals used in this synthesis were obtained from various chemical suppliers and used without further purification.

Zinc nitrate (Zn(NO3)2·6H2O, 98%, ChemPurPiekary Slaskie, Poland) and aluminum nitrate (Al(NO3)3·9H2O, 98%, ChemPurPiekary Slaskie, Poland) were used as the sources of cations while 3,4-dichlorophenoxy acetic acid (C9H9ClO3, 95%, Sigma-Aldrich Corporation, St. Louis, MO, USA) was used as the starting material of the guest anion. All solutions were prepared using deionized water. HDAC inhibitor Synthesis of materials The synthesis of Zn-Al-3,4D nanocomposites was performed by self-assembly method from a mixed aqueous solution of 0.1 M Zn(NO3)2·6H2O and 0.025 M Al(N03)3·9H2O at various concentrations of 3,4D PXD101 ic50 ranging from 0.0035 to 0.5 M. NaOH (2 M) was then added to the mixture with vigorous stirring under nitrogen atmosphere at a constant pH of 7.5 ± 0.02. The precipitate was aged for 18 h in an oil bath shaker at 70°C, filtered, thoroughly washed, and dried in a vacuum oven at 70°C. The

resulting nanocomposite was finely ground, kept in a sample bottle, and stored in a vacuum desiccator for further use and characterization. A similar procedure was performed for the preparation of ZAL except the addition of 3,4D. Characterization Powder X-ray diffraction (PXRD) patterns Tenofovir were recorded on a Rigaku model Ultima IV powder

λ diffractometer (Rigaku Corporation, Tokyo, Japan) using filtered Cu-Kα radiation (λ = 1.540562 Å) at 40 kV, 20 mA, and 2° min−1. Fourier transform infrared (FTIR) spectra were recorded using a PerkinElmer ×1,725 spectrophotometer (PerkinElmer, Waltham, MA, USA) in the range of 400 to 4,000 cm−1. Finely ground 1% www.selleckchem.com/products/apo866-fk866.html samples in KBr powder were compressed to obtain a pellet, and the pellet was then used to obtain the IR spectra. Thermogravimetric and differential thermogravimetric analyses (TGA/DTG) were carried out using a Mettler Toledo TGA/SDTA851 thermogravimetric analyzer (Mettler Toledo Inc., Columbus, OH, USA) with a heating rate of 10°C min−1 between 35°C and 1,000°C, under a nitrogen flow rate of 50 ml min−1. The elemental analysis was performed using a CHNS analyzer (model CHNS-932, LECO Corporation, St. Joseph, MI, USA) together with inductively coupled plasma atomic emission spectrometry using a PerkinElmer spectrophotometer (model Optima 2000DV) under standard condition. Results and discussion Powder X-ray diffraction Figure 2 shows the PXRD patterns of the ZAL and its nanohybrid material, zinc-aluminum-3,4-dicholorophenoxyacetate (N3,4-D), prepared using various concentrations of 3,4-D from 0.