Biofilm susceptibility assay The biofilms of S. aureus ATCC 29213 and S. epidermidis ATCC 12228 were prepared in 96-well flat-bottom polystyrene microtiter plates (Tarson, Mumbai, India), using a previously described method of Wei et al. [51] with a few modifications. This method was similar to the MIC assay for planktonic cells. The bacterial suspensions were prepared from the overnight

grown culture and the turbidity of the suspension was adjusted to 0.7 O.D.610 (≈1 × 109 CFU/ml). Twofold serial dilutions of boswellic Captisol supplier acids were prepared in 100 μl volume in tryptone soya broth (TSB; Difco laboratories) supplemented with 0.5% glucose in the wells of 96-well flat bottom microtiter plate. Forty microliters

of fresh TSB with 0.5% glucose was added to each well, followed by the addition of 60 μl of above bacterial suspension. This resulted in the final inoculum of 6 × 107 CFU/ml in each well: the final concentrations of the compounds ranged from (0.12 to 128 μg/ml). The plate was incubated for 18 h at 37°C. After completion of incubation, the planktonic cells were removed from each well by washing with phosphate buffer saline (Himedia, Mumbai, India). The biofilms were fixed with methanol for 15-30 min, stained with 0.1% (wt/vol) Crystal Violet (Sigma Chemical Co., St Louis, MO, USA) for 10 min and rinsed thoroughly with water until the negative control wells appeared colorless. Biofilm formation was quantified by the addition of 200 μl of 95% ethanol to the crystal violet stained wells and recording Nepicastat order the absorbance at 595 nm (A595) using a microplate reader (Multiskan spectrum, Thermo electron, Vantaa, Finland). The effect of AKBA was also examined on preformed biofilms. The biofilms Dimethyl sulfoxide were prepared by inoculating the suspension of S. aureus

and S. epidermidis into the wells of a polystyrene microtiter plate as mentioned above. After incubation at 37°C for 18 h, the culture supernatant from each well was decanted and planktonic cells were removed by washing the wells with PBS (pH 7.2). Two fold serial dilution of AKBA was prepared in TSB and 200 μl of each dilution was added to the biofilm in the wells. The plate was further incubated at 37°C for 18 h. The biofilm was fixed, stained and quantified as described above. Propidium iodide uptake assay The action of AKBA on cell membrane permeability of S. aureus ATCC 29213 cells was VRT752271 cost evaluated by the method as described by Cox et al. [52]. The bacterial cells were grown overnight in 100 ml of MHB at 37°C, washed and resuspended in 50-mmol/l sodium phosphate buffer, pH 7·1. The turbidity of the suspension was adjusted to 0.7 O.D.610 (≈1 × 109 CFU/ml). One milliliter volume of this suspension was added to flask containing 19 ml buffer and 64 μg/ml of AKBA.